Running The Gui Software - Hall Research Technologies UD2A-EDID User Manual

DVI Extender with EDID, Audio & Serial Control

4.3.2 Running the GUI software

The Main window will display when the GUI is run. The communication
parameters might need to be configured when running this UD2A-EDID
software for the first time. Please refer to the COM Configuration
window information setup below.
Figure 2 - Main
To open the COM Configuration window, select COM setting from the
Configuration menu. The GUI software will detect all COM ports
available on your PC. Select the COM port the UD2A-EDID-S is
connected to in the PORT drop down menu. When done, press CLOSE
button to save your port settings. The default settings for communicating
with the UD2A-EDID-S will be COM1, 4800 Baud, 8 bits, No Parity, 1
Stop bit, No flow control. The only parameter that can be changed is the
COM Port selection. The other parameters are configured as specified.
Figure 3 - COM Configuration
11