Pace DC550P Operator's Manual page 7

SAFETY INFORMATION (cont.)
Safety check
Upon completion of any servicing or repairs to your home terminal,
ask the service technician to perform safety checks to determine
that your home terminal is in its proper operating condition. See
also item 14 in the Important Safety Instructions.
SAVE THIS INFORMATION FOR FUTURE REFERENCE
The POWER OUTLET plug is designed only for connection to the AC
power cord for a TV. The maximum power it can supply is 500 watts.
Do not connect any equipment that uses more than 500 watts, or any
non-TV equipment such as a toaster or hair drier.
POWER OUTLET for TV only
120V AC 60Hz 4.2A max.
POWER INPUT
120V AC 60Hz 0.5A max. exc. outlet
120V AC 60Hz 4.7A max. inc. outlet
DOUBLE INSULATED
POWER INPUT
6
THIS DEVICE IS INTENDED TO BE ATTACHED
TO A RECEIVER THAT IS NOT USED TO RECEIVE
OVER-THE-AIR BROADCAST SIGNALS.
CONNECTION OF THIS DEVICE IN ANY OTHER
FASHION MAY CAUSE HARMFUL CABLE IN
INTERFERENCE TO RADIO COMMUNICATIONS
AND IS IN VIOLATION OF THE FCC RULES,
PART 15.
BYPASS
9V DC
100mA max.
The CABLE IN connector is designed for
connection to a cable network only.
You must not connect any other equipment,
such as a VCR, to this input.
Safety aspects of connections
Full details of the rear panel are on page 8.
Connecting
Do not connect your home terminal (or any other equipment such
as a TV or VCR) to the power supply until you have properly
connected all the other cables.
Your home terminal operates with a 120 V AC, 60 Hz power
supply. Do not connect your home terminal to any supply other
than this.
This home terminal is equipped with a two-wire power cord, with
a polarized plug at one end. The other end of the cord is fitted with
a polarized connector, which is shaped such that it can only be fitted
one way into the power input jack of your home terminal. Connect
this end first, before inserting the polarized plug into the wall
socket-outlet.
AUDIO OUT
Disconnecting
VCR
Disconnect your home terminal from the power supply before you
CAUTION
disconnect any other equipment from its rear panel.
RISK OF ELECTRIC S
DO NOT OPEN
The only way to disconnect your home terminal from the power
supply is to remove the power cord from the wall socket-outlet.
Your home terminal must therefore be installed near to the wall
socket-outlet, which should be easily accessible.