Pace DC550P Operator's Manual page 23

SOLVING PROBLEMS (cont.)
Check
Can you display menus
and guides on the screen?
YES
Is there any sound?
YES
Can you see and hear a
DVD that you are
trying to play?
YES
Can you see only
regular (analog)
channels but not any
digital channels?
22
Suggested solution
If your TV is connected to the VIDEO
NO
OUT or S-VIDEO OUT jacks, then you
will see menus and guides only if the
screen resolution is set to 480i.
Check that the audio cables are securely
NO
and correctly connected.
For the signal to loop through your
NO
home terminal from a DVD (or similar
equipment) to reach your TV, you must
activate baseband loopthrough by turning
off your home terminal.
The bypass feature may be turned on.
YES
Press the BYPASS button on your
remote control to turn the feature OFF
(make sure the word BYPASS is not
lighted on the front panel).
Further checks, if there is still a problem
Check the resolution setting (see page 16) and
change it if necessary.
Check that you have not muted the sound on your
home terminal and/or TV. Adjust the volume
control on your home terminal and/or TV.
If you can hear only mono sound, first check that
the program is likely to have stereo sound (an old
movie, for example, may not be in stereo).
Check that all the audio and video cables are
securely and correctly connected, including any to a
home theater receiver that you may be using to
enhance the sound.