6. Readjust the throttle cable barrel if the cam roller is touching
the cam.
b
a -
Throttle cam
b -
Cam roller
SHIFT CABLE INSTALLATION
Install cables into the remote control following the instructions
provided with the remote control.
1. Locate the center point of the slack or lost motion that exists
in the shift cable as follows:
a. Move the remote control handle from neutral into forward
and advance the handle to full speed position. Slowly
return the handle back to the neutral. Place a mark ("a")
on the cable end guide.
b. Move the remote control handle from neutral into reverse
and advance the handle to full speed position. Slowly
return the handle back to the neutral. Place a mark ("b")
on the cable end guide.
INSTALLATION
a
146
15952
eng