The Power switch on model 1330, 1331, 1334
series is located on the left side of the vacuum.
Push the rocker switch "ON" (I) to vacuum, and
"OFF" (O) when cleaning is complete.
NOTE: You can find your model number on the
back, bottom side of the vacuum on the white
sticker by the UL rating.
Press the handle release pedal with your foot
to place your CleanView vacuum into one of
three cleaning positions.
1. Upright – For storage and above floor
cleaning with tools.
2. Normal cleaning – Press handle release
for household floor cleaning tasks.
3. Low cleaning – With the vacuum in
normal cleaning position, press handle release
pedal again, use for reaching under low furniture
such as tables, chairs or beds.
There are five height settings available for
various floor surfaces. Turn the dial on the foot
of the cleaner to the desired setting.
Lowest setting – For low pile carpet or bare
floors. To pick up debris, it may be necessary
to move up one setting.
Medium setting – For medium pile carpet.
Highest setting – For high pile and most
NOTE: For optimal carpet cleaning performance,
adjust to the lowest practical setting. If your
cleaner is difficult to push, adjust to the next
If the dial is difficult to turn, tilt the cleaner
back slightly to take the weight off the foot
" Hair, string and small objects can
*Product images may vary
block the vacuum hose or tools.
Check them occasionally
Before using your vacuum, make sure that the dirt
tank is in the locked position and that both fi lters
(pre-motor and post-motor) are in place. Do not
operate your vacuum without these fi lters.
" Before cleaning under low furni-
ture, check area first for objects
that might harm the unit or block
the vacuum hose.
" Your vacuum features a Quick
Release™ cord wrap. To remove
the power cord quickly and
easily, rotate the upper cord
wrap toward the floor and slip
the power cord off the upper and
lower cord wraps.
5/15/14 12:44 PM