Table of Contents
Advertisement
RUNNING BACKUP SOFTWARE
LOAD RUN SOFTWARE
SYNC LOST !
Please check cables
HUB update init
HUB update retry
HUB update ...%
HUB update transfer
HUB update checksum
HUB update error
HUB update done
R59770419 FLX-60 12/05/2010
3. Components of an FLX display system
This message appears in case the FLX-NNI Controller unit runs
with backup software. This means that the main software is
corrupt and should be updated. Updating the software of the
FLX-NNI Controller unit has to be done with the Director toolset.
See user guide of the Director toolset for detailed instructions.
Note that the functionality of an FLX-NNI Controller unit which
runs with backup software is limited. The content of the first pixel
is copied on all other pixels.
This message appears in case the FLX-NNI Controller unit does
not find a sync signal on the data input socket (IN). Check all data
cables in the upstream of the system.
After a few seconds this message will be replaced by the root
menu. In the lower left corner of the root menu the message '!
NO SYNC !' will remain.
This message appears when initializing the software update
process for all FLX-HUB units connected with the FLX-NNI
Controller unit.
This message appears when the first attempt to update the
software for all FLX-HUB units connected with the FLX-NNI
Controller unit failed.
This message appears during the software update process of all
FLX-HUB units connected with the FLX-NNI Controller unit.
This message appears during the transfer in the update process
of all FLX-HUB units connected with the FLX-NNI Controller unit.
This message appears during the checksum in the update process
of all FLX-HUB units connected with the FLX-NNI Controller unit.
This message appears in case an error occurred during the
update process of all FLX-HUB units connected with the FLX-NNI
Controller unit.
This message appears in case the update process of all FLX-HUB
units connected with the FLX-NNI Controller unit was successful.
29
Advertisement
Table of Contents
