What’s in the carton? ITEM PART NUMBER DESCRIPTION REVISION NUMBER 68800065 CONDENSER PAD INSTALLATION SCREW 68800066 SCREW #8 X 5/8” TRUSS HEAD 1. Breeze indoor module with 25 ft. connecting 68800085 SCREW #8 X 1 1/2” PHILLIPS PAN HEAD line attached 68800086 WALL ANCHOR FOR #8 SCREW 2.
Page 3
Next, determine how you will connect the indoor and outdoor modules. There are two options available: OPTION 1 is to drill a 3” hole through the wall to pass OPTION 2 is to use the Friedrich SimpleSill™ kit to pass the connecting line through. the connecting pipe through the window. The Simple- Sill™...
Page 4
Now that you have determined where the modules will be placed it is time to install the Breeze air conditioning system. STEP 2 – Hang wall mount bracket Using the paper template as a guide locate two studs behind screw hole locations in the template. It is preferrable to mount the hangaing plate on studs.
Option 2: Window Installation Using Friedrich SimpleSill™ A. With the window raised, place one end of the SimpleSill™ into the window opening so it is against the corner of the window frame and sill. Raise the other side of the SimpleSill™ 4” above the window sill. Expand the SimpleSill™ the width of the window and install the securing pin as shown.
Page 6
STEP 7 – Connect the quick connector from the indoor line set to the outdoor module. 1. Open lock handle on line-set connec- connector on outdoor unit half way and 5. Grasp lock handle and rotate to its tor by pulling back and rotating toward release outer lock collar.
The outer cover of the Breeze indoor module can be cleaned with a damp cloth. Cleaning the outdoor module can be done by rinsing the module with low pressure water. Refer to friedrich.com for approved coil cleaning agents. Cleaning the filter: The indoor module of the Breeze system has a washable filter that should be inspected and cleaned periodically.
Remote Control Operation START / STOP Turns the Breeze unit on or off. DN/UP Arrow Press to raise or lower the temperature setting. Temperature setting range is between 61�F – 86�F. FAN/AUTO Adjusts the fan speed or sets fan to ‘AUTO’ operation. Selectable speeds are LOW, MEDIUM, HIGH or AUTO.