8
8
Firebox Setup
A. Remove the Shipping Materials
Remove the shrink film, corrugated top cap, bottom cap
and column protectors from the firebox.
Remove shipping materials from inside or underneath the
firebox.
B. Clean the Firebox
•
Clean/vacuum any sawdust that may have accumu-
lated inside the firebox.
C. Hood Installation
WARNING: A hood is furnished with each firebox and
MUST be installed for safe operation.
Locate the (6) screws, (4 on the top and 1 on each
end),slide hood into position and secure. See Figure 8.1.
Figure 8.1
WARNING! Risk of Fire!
modified or replaced with a hood that may be provided with
the vent free appliance.
Outdoor Lifestyles • VOFB36/42 Installation Manual • 4153-901 • Rev B • 04/23
The firebox hood must not be
D. Adjustable Firebox Supports
This firebox is provided with adjustable supports to allow
for proper support of the firebox bottom and reduced sag-
ging caused by heavy concrete logs.
To adjust firebox supports:
1. Remove (2) screws securing Lower Access Panel.
See Figure 8.2.
Figure 8.2
2. Using a flat screwdriver, lift gently on Lower Access
Panel. See Figure 8.3.
Figure 8.3
19