Table of Contents
Advertisement
8.2. COM PORT SETTING - RS-485 interface setting
Define telemetry protocol type and transmission rate in this menu.
MENU > COM PORT SETTING > Enter
Select port 1 or 2 and confirm with Enter.
Use the joystick
to change the value.
Selection: 1200, 2400, 4800, 9600 Baud.
Press Enter to confirm the setting and Esc to cancel.
The next menu is used for telemetry protocol
setting.
Use the joystick
to change the value.
Selection:
EVF-1:
EVF-2:
A-Type:
Pelco-D
Pelco-P
ATTENTION: Protocol type setting is irrelevant for EverFocus DVR control; only baud rate setting is
relevant!
Press Enter to confirm the selection and Esc to cancel.
8.3. DEVICE SETTING
Connection settings definition for controlled devices.
8.3.1. Camera setting
Use this menu to define telemetry cameras and cameras to be assigned to DVR call and matrix monitors.
Cameras assigned to DVR main monitor do not require these settings.
MENU > DEVICE SETTING > CAMERA SETTING > Enter
Camera number 1 ~ 9999 (independent of RS-485 address!)
Press Enter to confirm the setting and Esc to cancel.
Telemetry camera RS-485 address setting.
Enter any idle address for fixed cameras (numeric
entry is compulsory).
Press Enter to confirm the setting and Esc to cancel.
V-Protect Speed Dome
EverFocus EPTZ series
EverFocus ED2200/2250,
Samsung SCC-641/643/6405
15
Port : _ ( 1 or 2 )
Input the port.
BAUD : 9600 <
[ ↑ ↑ ↑ ↑ ↓ ↓ ↓ ↓ ] to change
Protocol : EVF-1
[ ↑ ↑ ↑ ↑ ↓ ↓ ↓ ↓ ] to change
Port : 1 Changed
[ ENT ] to save
_ _ _ _
Camera Name :
RS485 Address:
_ _ _ _
Advertisement
Table of Contents
