Com Port Setting - EverFocus EKB500 User Manual

4.1. COM PORT SETTING

Port : _ ( 1 or 2 )
Input the port.
BAUD : 9600 <
[ ] to change
Protocol : EVF-1
[ ] to change
Port : 1 Changed
[ ENT ] to save
When the setting is saved, the display will go back to the COM Port Setting.
Enter another port to set, or Esc to quit the COM Port Setting.
Note: It's important to select a correct Baud Rate and protocol for the device
connection, and please do not connect devices with different protocols/baud
rate to a COM port. For example: If you have 3 devices on Port 1 of the
Select "COM Port Setting" (The line is
flashing), and press Enter to enter the
COM Port Setting, or Esc to go back
main setup menu. Key in the port you
want to set (1 or 2), and then press Enter.
Switch Joystick up/down to change the
Baud Rate, and then press Enter. The
available Baud Rates are 1200, 2400,
4800 and 9600.
Switch Joystick up/down to change the
protocol, and then press Enter. The
available protocols are EVF-1, EVF-2,
A-TYPE, PELCO-D and PELCO-P.
After finishing setting, you need to press
Enter to save the setting.
11