Wiring The Fan - Hunter Type 2 Owners And Installation Manual

Receiver
Steps 6-3 – 6-7
Large Wire
Connector
Small Wire
Connector
6 • Wiring the Fan
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
6-1. Make sure the power is still off.
Antenna
6-2. To connect the wires, hold the bare metal leads together and place
a wire connector over them, then twist clockwise until tight. For
all these connections use the wire connectors provided.
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
6-3. Connect the bare or green ground wire (grounding) from the
ceiling to the green ground wire (grounding) from the ceiling plate
and the green ground wire (grounding) from the fan, or the green
ground wire on the low profile washer if you chose the low profile
option.
6-4. Using the large wire connectors, connect the white wire
(ungrounded) and the black wire (ungrounded) from the ceiling
as follows:
• The white (common) power wire (ungrounded) from the ceiling
to the white wire (ungrounded) from the receiver (marked on
white tag "COMMON IN")
• The black power wire (ungrounded) from the ceiling to the
black wire (ungrounded) from the receiver (marked on white
tag "LIVE IN")
6-5. Using the small wire connectors, connect the wires from the fan as
follows:
• The black wire with a white stripe (ungrounded) from the fan
to the black wire with a white stripe (ungrounded) from the
receiver (marked on red tag "LIGHT OUT")
• The black wire (ungrounded) from the fan to the red wire
(ungrounded) from the receiver (marked on white tag
"FAN OUT")
• The white wire (ungrounded) from the fan to the white
wire (ungrounded) from the receiver (marked on white tag
"COMMON OUT")
13
45019-01 • 06/03/11 • Hunter Fan Company