Hunter Type 2 Owners And Installation Manual page 19

9 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
9-9. Remove the lower switch housing screws, then
remove the lower switch housing.
9-10. Disconnect the male / female terminals on both white
and black wires.
9-11. Remove the wire connectors on both the white and
black wires.
9-12. Remove the nut and washer from inside the lower
switch housing. Separate the light fixture from the
lower switch housing.
9-13. Use the dummy terminals (included) to cover the
ends of the black and white wires in the lower switch
housing. The black wire receives the female dummy
terminal, and the white wire receives the male dummy
terminal.
9-14. Install the switch housing cap and plug button to the
lower switch housing.
9-15. Store the light fixture, nut, washer, and lead wires for
possible future use.
Male
Dummy
Terminal
Step 9-13
Female
Dummy
Terminal
19
45019-01 • 06/03/11 • Hunter Fan Company
Nut
Male / Female
Terminals
(shown
disconnected)
Lead
Wire
Wire
Connector
Steps 9-9 – 9-12
Plug Button
Step 9-12
Washer
Lower
Switch
Housing
Screw
Lower Switch
Housing
Threaded
Rod
Switch
Housing
Cap