Rear Panel - Kenwood TM-G707 Instruction Manual

1
2
3
4
5
6
!4 !4 !4 !4 !4 MNU button
7
Selects the Menu mode {page 19}.
8
!5 !5 !5 !5 !5 PM button
9
10 Selects the Programmable Memory mode {page 36}.
11
!6 !6 !6 !6 !6
(POWER) switch
12
Switches the transceiver ON or OFF {page 15}.
13
!7 !7 !7 !7 !7 Microphone connector
14
Insert the 8-pin modular connector plug until the
15
locking tab "clicks".
16
UP
DC 8 V, 200 mA max.
17
GND
STBY (PTT)
18
GND (MIC)
MIC
19
NC: No connection
DWN
20
!8 !8 !8 !8 !8 DATA connector
21
Connect a Terminal Node Controller (TNC) for Packet
22
operation. Accepts a 6-pin mini DIN plug {page 6}.
12

REAR PANEL

q q q q q Antenna connector
Connect an external antenna {page 5}. When making
test transmissions, connect a dummy load in place of
the antenna. The antenna system or load should
have an impedance of 50 Ω. The TM-G707E accepts
a male N-type connector and other versions accept a
male PL-259 connector. This transceiver has only
one antenna connector because of a built-in duplexer.
w w w w w Power Input 13.8 V DC cable
Connect a 13.8 V DC power source. Use the
supplied DC power cable {pages 3 and 4}.
e e e e e Speaker jack
If you wish, connect an optional external speaker for
clearer audio. This jack accepts a 3.5 mm (1/8")
diameter, 2-conductor plug. See page 6 for more
information. The right jack is unavailable.