■
Fixed Station Operation
1
In order to use this transceiver for fixed station
operation, you will need a separate 13.8 V DC power
2
supply that must be purchased separately. The
3
recommended current capacity of your power supply
is 12 A.
4
5
1 Connect the DC power cable to the regulated DC
power supply and check that polarities are correct
6
(Red: positive, Black: negative).
7
• DO NOT directly connect the transceiver to an AC
outlet!
8
• Use the supplied DC power cable to connect the
9
transceiver to a regulated power supply.
10
• Do not substitute a cable with smaller gauge wires.
11
Fuse holder
12
13
Red (+)
14
Black (–)
15
16
17
18
19
20
21
22
4
Regulated DC power
supply
To AC outlet
2 Connect the transceiver's DC power connector to
the connector on the DC power cable.
• Press the connectors firmly together until the locking
tab clicks.
Press
firmly.
Note:
◆
For your transceiver to fully exhibit its performance capabilities,
the following optional power supply is recommended:
PS-33 (20.5 A, 25% duty cycle).
◆
Before connecting the DC power supply to the transceiver, be
sure to switch the transceiver and the DC power supply OFF.
◆
Do not plug the DC power supply into an AC outlet until you
make all connections.
Fuse holder