Recalling Memory Channels; Clearing Memory Channels - Kenwood TM-G707 Instruction Manual

RECALLING MEMORY CHANNELS

1 Press [MR] to enter Memory Recall mode.
• The memory channel used last is recalled.
2 Turn the Tuning control, or press Mic [UP]/ [DWN], to
select the desired memory channel.
• You can also recall memory channels by directly
entering numeric digits via the microphone keypad
(MC-53DM only). See page 54.
• You cannot recall empty memory channels.
• To restore VFO mode, press [VFO].
You may want to recall only memory channels that store
frequencies of the current band. Access Menu No. 4
(MR) to select "ONE". The default is "ALL".
ONE: Recalls only memory channels of the current
band.
ALL: Recalls all programmed memory channels. For
example, allows you to recall a VHF frequency
channel when operating the UHF band.
Note:
◆
When you recall an odd-split memory channel, "–" and "+" appear on
the display. Press [REV] to display the transmit frequency.
◆
After recalling a memory channel, you may program data such as
Tone or CTCSS. These settings, however, are cleared once you
select another channel or the VFO mode. To permanently store the
data, overwrite the channel contents {page 28}.

CLEARING MEMORY CHANNELS

1 Recall the desired memory channel.
2 Switch OFF the power to the transceiver.
3 Press [MHz]+[ ].
• A confirmation message appears.
1
4 Press [OK] .
• The contents of the selected memory channel are
erased.
1
2
3
4
5
2
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
29