Siemens Standard, Advance, Advance Plus, Advance Conference Telephone Manual page 11

1
4
Figure 7. Installation of Bay Option Modules
1. Disconnect the phone line from the wall jack or phone and
place the phone
down.
2. Hold the adapter
down and mount it in one of the two mounting locations on
the bottom of the phone, sliding the two tabs
slots .
3. Gently press down on the adapter until the male connector
strip is inserted all the way into the female connector strip .
For the Analog Adapter, connect an analog device to the 6-pin
RJ11 port on the back of the Analog Adapter (connecting tip/
ring to pins 3 and 4). Reconnect the phone line to the phone.
Note that the analog adapter requires the Optiset E Local Power
Supply for operation.
For the Control Adapter, connect the personal computer to the
9-pin (RS-232) connector on the back of the Control Adapter.
8
2
3
5
on a soft surface with the keypad facing
with the male connector strip facing
into the two