Table of Contents
Advertisement
Enter Configuration
Ì$+;Î
This parameter allows up to three characters to be replaced from the barcode read. These
substitutions are stored in memory. To define each character replacement:
Read one of the following character replacement codes:
From the Code Identifier Table in Appendix
family.
0 = character replacement will be effective for all code families.
From the Hex/Numeric Table read two characters corresponding to the Hex value (00-FE) which
identifies the character to be replaced. For Wedge and USB-KBD interfaces, it is also possible to
read the Special Key(s) on page 53.
From the Hex/Numeric Table read two characters corresponding to the Hex value (00-FE) which
identifies the new character to replace. For Wedge and USB-KBD interfaces, it is also possible to
read the Special Key(s) on page 53.
FF = the character to be replaced will be substituted with no character, that is, it will be
removed from the code.
56
DATA FORMAT
C
R
HARACTER
EPLACEMENT
disable character replacement
ÌEO0mÎ
first character replacement
ÌEO1pÎ
second character replacement
ÌEO2sÎ
third character replacement
ÌEO3vÎ
B
, read the Code Identifier for the desired code
Exit and Save Configuration
Ì$-?Î
Advertisement
Table of Contents
