Table of Contents
Advertisement
2 INSTALLATION
2.1
USING YOUR DELFISCAN M80 READING SYSTEM
Follow the procedure below to start using your DelfiScan M80 reading system:
1.
Connect a DelfiScan M80 cradle to the Host.
2.
Insert the DelfiScan M80 reader into the cradle to start the battery charging. A full
charge of the Lithium battery takes 3.5 – 6 hours.
To achieve the best battery life, it is recommended to perform a full battery
charge before using the reader in hand-held mode.
NOTE
In hands-free use, you can immediately start using the reader, since it is powered by
the cradle.
3.
Configure the DelfiScan M80 reader.
4.
Configure the DelfiScan M80 cradle.
2.2
CHANGING THE BATTERIES
To change the battery of your reader, you must:
1.
Unscrew the battery cover screw (Figure 1).
2.
Unplug the white connector and remove the old battery (Figure 2).
3.
Insert the new battery and plug in the white connector.
When inserting the new battery into the handle pay attention to position the
battery and the connector just as shown in Figure 3.
NOTE
Figure 1
Figure 2
Figure 3
INSTALLATION
3
Advertisement
Table of Contents
