Table of Contents
Advertisement
2.3
SYSTEM CONNECTIONS
Connections should always be made with power OFF!
CAUTION
You can connect the DelfiScan M80 cradle to the Host through the dedicated connector,
using the cable corresponding to the desired interface type.
1.
Connect the appropriate interface cable to the cradle by simply plugging it into the
Host connector on the base of the cradle.
DelfiScan M80 Cradle - Bottom View
To disconnect the cable, insert a paper clip or other similar object into the hole
corresponding to the connector on the base of the cradle. Push down on the clip while
unplugging the cable. Refer to the following figure:
Interface Cable
Disconnecting the Cable
INSTALLATION
5
Advertisement
Table of Contents
