Clock Adjustment - Kenwood XD-980MD Instruction Manual

6 8

Clock adjustment

When the AC cord is connected to a receptacle, the clock
display starts to flash. Set the correct time following the
instructions.
Time display is made only when the unit is switched off.
Ensure that the unit is OFF.
1
Activate the clock adjustment mode.
2
Enter the figure of hour.
1
2
3
Enter the figure of minute.
1
2
AUTO
MULTI CONTROL
/VOLUME
To decrease
the figure
ENTER
MULTI CONTROL
/VOLUME
To decrease
the figure
ENTER
Example: Adjustment to 8:45
To increase
the figure
To increase
the figure
Adjust the clock before setting the timer.
A M 1 2 ) ) :
The time display starts to blink.
A M 8 ) ) :
The time of the day is represented in 12-hour AM/PM method.
Press the ENTER key. The hour is entered and the minute
display starts to blink.
A M 8 4 5 :
If you make a mistake, restart from the beginning.
To adjust correct time, press the ENTER key at the same
moment as a time announcement.
The time display flashes when a power failure has occurred or
when the power plug has been pulled and inserted again. In
such a case, set the clock again.
Timer operation
XD-980MD (En)