Kenwood XD-9581MD Instruction Manual page 81

Component system/compact hi-fi system
Table of Contents

Advertisement

MD recorder section (Displayed messages and actions to be taken against them)
Displayed Message
NO DISC
001 SCMS
DISC FULL
TITLE FULL
BLANK DISC
NO TRACKS
DISC READING
DISC WRITING
DISC ERROR
CAN NOT EDIT
ok?(blinking)
PROTECTED
UNRECORDABLE
*1 All minidiscs contain a Table of Contents (TOC) in addition to sound
signals. The TOC is similar to the table of contents in a book and
contains information, such as track numbers, track length, and charac-
ter information, that cannot be rewritten.
*2 In addition to the TOC, minidiscs also contain a special User's Table of
Contents (UTOC) that contains track number, track length, and charac-
ter information, that can be rewritten.
Meaning
÷ No disc is placed on the tray.
÷ An attempt is made to record digital signal from
a source while its digital copy has been prohib-
ited by SCMS.
÷ There is no recordable area on the disc.
÷ An attempt is made to record a 256th track.
÷ An attempt is made to assign a title with more
characters than usable.
÷ The disc does not contain any recordings.
÷ The disc does not contain any tracks but has a
disc title.
÷ The TOC *1 data of the disc is being read.
÷ The data related to editing or recording is being
written in the disc.
÷ The contents of UTOC *2 are abnormal.
÷ An attempt is made to perform editing beyond
the restrictions, for example to erase a track
which is too short.
÷ This is a message for confirming if editing can
really be executed.
÷ The minidisc is write-protected.
÷ The minidisc is only for playback.
Memory Backup for the MD Recorder Section
At the time of unit OFF (STANDBY), or when the power plug is
pulled from the outlet, the memory contents will remain stored
for about one day. In case of long power failures or long times
with the plug pulled from the receptacle, the information in
regard to recording or editing (recorded when the minidisc is
removed) may be erased or destroyed) before recording on
the minidisc. Once the information has disappeared, it can not
be recovered.
After recording or editing, always remove the minidisc to record
the recording or editing information.
In case of difficulty
XD-9581MD (En)
Action
÷ Load a disc.
÷ Switch to analog recording.
÷ Use another recordable disc.
÷ More than 256 tracks cannot be re-
corded per disc.
÷ Refer to "Total number of title charac-
ters".
÷ When playback is required, use a re-
corded disc.
÷ The disc can be used for recording
without any problem.
÷ This is a normal operation.
÷ This is a normal operation.
÷ Perform "ALL ERASE" operation. If
this is not possible, use another disc.
÷ Perform editing following the restric-
tions.
÷ Press the ENTER key to execute edit-
ing.
÷ Cancel the write protection.
÷ Insert a minidisc for recording.
81
k
U
5
j

Advertisement

Table of Contents
loading

Table of Contents