Xd-750/700/550/500 (En - Kenwood XD-500 Instruction Manual

Muting the sound temporarily
MUTE
EX
C D ) 1
Remote control unit
Press again to resume the original volume.
The sound muting is also canceled when the volume is controlled.
Bass compensation
(N.B.: Natural Bass circuit)
(Remote control unit only)
N.B.
Remote control unit
Each press of the key switches the setting.
1 NB ........... The low frequencies are compensated
according to the current volume level.
(Effective for low-level listening)
2 NB 2 ........ The low frequencies are compensated
regardless of the volume level.
3 NB OFF (N.B. deactivated)
When CD has been selected.
EX . BASS
C D ) 1 ) ) )
B
EX . BASS
V O L
B
(Remote control unit only)
Blinks
. BASS
1 5 ) :
B
Lights
N.B.
N B 1
CLASSIC
ROCK EQ. POP
:
MANUAL
1 2 3
4
5
3
2
REV.MODE
1
RUNNING
INDICATOR
10
11
Volume display
CLASSIC
ROCK EQ. POP
2 )
MANUAL
1 2 3
4
5
3
2
REV.MODE
1
RUNNING
INDICATOR
10
11
Listening through headphones
1 Insert the headphone plug into the PHONES jack.
PHONES
1
REV.MODE
The sounds from all speakers are cut off.
2 Adjust the volume.
Bass and treble compensation
The EX.BASS (Extra Bass) function compensates for the high
and low frequencies and has been set to on before the sys-
tem left the factory.
EX.BASS
Each press switches EX.BASS on and off alternately.
AUTO POWER SAVE function
When the power is ON and neither recording nor playback is
executed for 30 minutes or more, the power is switched off au-
tomatically by this function. This function can be made active
or not active by the following operation.
Press when the
power is OFF.
BEST
HITS
Each press switches the modes as follows.
VOL.
6
1 ON..... Auto power save is used.
7
2 OFF....Auto power save is not used.
8
9
This function is not available when the AUX input is selected. When
the TUNER input is selected, it is available only when the volume is
set to 0.
STANDBY mode of ON/STANDBY switch
VOL.
When the power cord of this system is plugged into an AC out-
let, the display lights up regardless of the ON/OFF setting of the
6
7
ON/STANDBY switch. This indicates that a small amount of cur-
8
rent is being supplied to the unit to back up the memory con-
9
tents. This mode is referred to as the Standby mode. While the
display is lit, the power of the system can be switched ON/OFF
from the remote control unit.
Let's put out some sound

XD-750/700/550/500 (En)

MULTI CONTROL
/VOLUME
EX . BASS
C D ) 1
E R s A V E O N .
1 7