Operation Of Remote Control Unit - Kenwood XD-500 Instruction Manual

Operation of remote control unit

1 4
Loading batteries
1 Remove the cover.
Operation
Plug the power cord into the mains power outlet and press
the (on/standby) key of the remote control unit to
turn power ON. After the power has been turned ON, press
the desired key.
To turn power off, press the
The system enters the standby mode in which only the
time display is lit.
When pressing more than one remote control keys successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries with new ones.
Notes Notes
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.
In such a case, change the installation position to avoid malfunction.
2 Insert batteries.
Insert two R6 ("AA"-size) batteries fol-
lowing the polarity indications.
(on/standby) key again.
3 Close the cover.
30
30
Model: RC-H3R/H2R
Infrared ray system
XD-750/700/550/500 (En)
Remote sensor
6 m
Operating range (approx.)