Copying Tape (Tape Dubbing); Xd-750/700/550/500 (En - Kenwood XD-500 Instruction Manual

Copying tape
(Tape dubbing)
The contents of the tape in deck A can be copied onto the
tape in deck B.
1 Select the "TAPE" input.
2 Load tapes in the decks.
3 Select "[" (double-side recording)
or """ (one-side recording).
4 Use the same tape transport direc-
tions.
(1) Select the deck to change the
transport direction.
(2) Press the play key corresponding
to the desired direction.
(3) Stop playback.
5 Start dubbing.
Press during stop.
The DOLBY NR key is not active in dubbing mode. The tape recorded on deck B assumes the same Dolby NR condition as the tape played on
deck A.
Note Note
INPUT
REV. MODE
A/B
2 7 3
1 ¡
7
DUBBING
A
Playing tape
Check the tape transport direction indicators.
EX . BASS ECHO
T A P E ) ) ) )
B
Running direction
When recording is started, the tape will be transported in the direction
selected in this step.
EX . BASS ECHO
T A P E ) ) 1 2
B
Dubbing ends automatically when the side(s) to be dubbed has been
completed.
To stop dubbing
The deck B will stop after creating a non-recorded portion of about
4 sec, and then the deck A will stop.
Dubbing can also be stopped by pressing the stop (7) key. Note that
the non-recorded space is not created in this case.
Let's record

XD-750/700/550/500 (En)

A
Recording tape
CLASSIC
ROCK EQ. POP
MANUAL
VOL.
REV.MODE
RUNNING
INDICATOR
CLASSIC
ROCK EQ. POP
MANUAL
VOL.
DUBBING
REV.MODE
RUNNING
INDICATOR
DUBBING
2 9