How To Use The Pre Out Power In Jacks; Dolbyized Fm Broadcasts Reception - Kenwood KR-9600 Instruction Manual

OPERATING INSTRUCTIONS
HOW TO USE THE PRE OUT POWER IN JACKS (1)
When it is desired to set up a 4 CHANNEL stereo system.
remove the attached jumper connector and connect another decoder
amplifier or demodulator to the PRE OUT POWER IN jacks at rear of
the receiver. I n this case. turn the FM 25 f..Ls switch to OFF. It must be
remembered. however. that a 4 CHANNEL program source is neces­
sary for such operation. See figure below (A).
HOW TO USE THE PRE OUT POWER IN JACKS (2)
• Dolbyized FM Broadcasts Reception
1. Remove the attached jumper connector and connect the Dolby
NR adaptor to the PRE OUT POWER IN jacks as shown in the fi­
gure below (B).
2. Set the SELECTOR switch to FM and tune in to a Dolbyized FM
Broadcast.
3. Turn the FM 25 f..Ls switch (on the front panel) to ON.
NOTE: When using the PRE OUT POWER IN jacks do not use the attached jum ­
per connector for other jacks. Keep it. because it must be plugged back
into these jacks when it is not used.
A
p:
SIGNAL
:0:
k
KR-9600
FM 25
115
SWITCH
(5
'0
PRE OUT
POWER IN
IN
.a
REAR
SPEAKER
rrJ
Cd
l
~_--.r--------tC3
. [(]
4CH DECODER AMP
11 KR-9600 (K)
• Dolby System Recording and playback
Recording
1. Connect the Dolby adaptor output jacks to the tape deck
LINE-INPUT jacks.
2. Select the program source of your choice with the SELECTOR
switch.
3. Turn the FM 25 f..Ls switch to OFF. (When recording Dolbyized
FM Broadcasts depress the FM 25 f..Ls switch to ON.)
Playback
1. Remove the attached jumper connector and connect the. tape
deck LINE-OUTPUT jacks to the input jacks of the Dolby adaptor.
2. Turn the FM 25 f..Ls switch to OFF and playback your Dolbyized re­
cordings. See figure below (C).
B
DOLBY
ADAPTOR
c
aaEBEBaa
LINE INPUTI I LINE OUTPUT
INI lOUT
DOLBYIZED
FM STEREO
BROADCAST
KR-9600
POWER IN
SIGNAL
DOLBYIZED
FM STEREO
BROADCAST
KR-9600
SIGNAL