ADJ Quad Phase HP User Instructions page 6

Quad Phase HP
DNST
- This mode can be used as a precaution mode, that
in case the DMX signal is lost, the operating mode chosen
in the setup is the running mode the fixture will go into when
the DMX signal is lost. You can also set this as the operat-
ing mode you would like the unit to return to when power is
applied.
1. Press the MENU button until "DNST" is displayed, press
ENTER.
2. Either "MAST", "BLND", or "LAST" will be displayed. Choose
an operating mode you would like the unit to start up in when
power is applied or the DMX signal is lost.
• MAST (Master Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode.
• BLND (Blackout) - If the DMX signal is lost or power is applied,
the unit will automatically go into stand by mode.
• LAST (Last State) - If the DMX signal is lost the fixture will stay
in the last DMX set up. If power is applied and this mode is set,
the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up
LED -
With this function you can switch the LED on or off
via the control board.
1. Press the either the MENU button until "LED" is displayed,
press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to switch on the LED, or "OFF"
to switch off the LED.
3. Press ENTER to confirm and exit.
ADJ Products, LLC - www.adj.com - Quad Phase HP Instruction Manual Page 10
System Menu
Quad Phase HP
DISP -
1. Pres the either the MENU button until "DISP" is displayed,
press ENTER.
2. Press the UP button to select "DSIP" to activate this func-
tion, or "DISP" to deactivate this function.
3. Press ENTER to confirm.
TEST -
1. Press the MENU button until "TEST" is displayed, press ENTER.
2. The unit will now run a self test. Press the MENU button to exit.
TEMP
temperature of the unit.
1. Press the MENU button until "TEMP" is displayed, press
ENTER.
2. The current running temperature of the fixture will now be
displayed. Press MENU to exit.
FHRS
time of the unit.
1. Press the either the MENU button until "FHRS" is displayed,
press ENTER.
2. The display shows the running time of the unit. Press MENU
to exit.
VER
the unit.
1. Press the either the MENU button until "VER" is displayed,
press ENTER.
2. The display will show the software version.
This function will reverse the display 180º.
This function will run a self test program .
- With this function you can display the running
- With this function you can display the running
- Use this function to display the Software version of
ADJ Products, LLC - www.adj.com - Quad Phase HP Instruction Manual Page 11
System Menu