Table of Contents
Advertisement
G. OGM RECORDING
1.
Press the 5 key. The unit will prompt "Please record your announcement after the beep.
To stop recording, press star (*)."
2.
After hearing a long beep, begin your announcement. The maximum recording time is 30
seconds.
3.
Press star (*) to stop recording and the Excursion
once for your review.
H.
OGM PLAYBACK
1.
Press the 8 key and the Excursion
OGM, the Excursion
I.
RECORDING A MEMO
1.
Press the 4 key and the Excursion
after the beep. To stop press star (*)."
2.
After hearing a long beep, begin your recording. The maximum recording time is
minutes.
3.
Press star (*) to stop recording.
J.
PLAYBACK MESSAGES / MEMOS
1.
Press the 7 key for Incoming Message (ICM) / Two-Way Recording playback or press 3
key for Memo message playback. The Excursion
(number) (new) (Memo) message."
K.
PLAYBACK OPTIONS
Review Previous Message : Press 7, to go to the previous message.
Repeat Messages: Press 8, to restart the same message from the beginning.
Skip Message : Press 9, to skip forward to the next message .
Erase a Message : Press 0, to erase a particular message.
Stop Message Playback : Press * , to terminate message playback.
®
NOTE: The Excursion
39606 will announce "End of message." when all messages have
been played.
IMPROVING CORDLESS RECEPTION
Follow these guidelines to improve cordless sound quality:
•
Select an area to install the Excursion
home or office. This will improve the operating range of the unit.
•
®
Keep the Excursion
Interference (RFI) is sometimes generated by these appliances, which can cause a
degradation in cordless reception.
•
Set the base unit antenna to its vertical position.
•
Keep the handset batteries charged as much as possible. Weak handset batteries can
limit the range of cordless operation.
MAXIMIZING BATTERY LIFE
Repeated use or recharge of Ni-Cd batteries without periodic full discharge results in reduced
useable charge time. When you notice the usable charge duration decreasing, fully discharge
the Ni-Cd battery and recharge as described:
DISCHARGING
Unplug the telephone line cord from the Excursion
1.
Make sure that the adapter is connected.
2.
Lift the handset out of the base cradle.
3.
Press the TALK button of the handset (IN USE LED indicator should light) and start
4.
discharging.
Once the BATT LOW LED indicator starts flashing, it means that the battery level is low. Let it
fully discharge for 12 hour. Once the Ni-Cd battery is fully discharged, you may now charge
the battery to its full capacity.
®
39606 will playback the OGM recorded. If there is no
®
39606 will announce "Please enter next command".
®
39606 will prompt, "Please record your message
®
39606 where it is closest to the center of your
39606 base unit away from electrical equipment. Radio Frequency
®
39606 will automatically playback
®
39606 will announce "You have
®
39606 .
2
Advertisement
Table of Contents
