Table of Contents
Advertisement
B. SKIPPING MESSAGES
Press the
(Skip) button on the base unit during message playback to skip the next
message.
C. PREVIOUS MESSAGES
Press
( (Previous) button once on the base unit during
message playback to skip backward one message.
D. STOP MESSAGE PLAYBACK
Press the STOP button to stop message playback.
ERASING MESSAGES
A.
SELECTIVE ERASING
1.
Press the ERASE button on the base unit during message playback.
®
2.
The Excursion
39606 will announce "(Message) (Memo)
(number) erased." and then start the next message.
NOTE: Erased messages cannot be retrieved. There is a
momentary delay after erasing messages to allow the
®
Excursion
39606 to reorganize and optimize its memory space.
B.
ERASING ALL ICM AND TWO-WAY RECORDINGS
1.
In standby mode, press and hold the ERASE button for about 2 seconds.
®
2.
The Excursion
39606 will announce "Message (number) erased. You have no
message."
C.
ERASING ALL MEMO MESSAGES
1.
In standby mode, press the ERASE button briefly for less
than 2 seconds and press and hold MEMO button for about
2 seconds.
®
2.
The Excursion
39606 will announce "Message erased. You
have no Memo message".
D.
ERASING OGM
1.
During OGM playback, press ERASE button.
®
2.
The Excursion
39606 will announce "Erase your announcement. You have no
announcement."
NOTE: After erasing messages during memory full or near memory full, you may hear a
continuous beep for several seconds indicating memory sorting of the unit.
MEMORY FULL DETECTION
The memory full condition occurs:
•
If 15 minutes of recording time is reached, or
•
If 59 messages (i.e. Memo, OGM, ICM) have been recorded.
In this case, the ANS. ON/OFF LED indicator will blink in answer on mode. If there is an
incoming call, the unit will answer at the 10
any or all the messages remotely after listening to them. Refer to the REMOTE OPERATION
section for more details.
NOTE: Sometimes you may fail to escape from memory full condition when erasing a short
message. In this case, you must erase more messages (at least 1 minute message).
CALL SCREENING
You can listen to the caller leave their ICM and decide if you want to answer the call.
A.
FROM THE HANDSET (Away From the Base Unit)
®
1.
When the Excursion
button on the handset. The Excursion
immediately answer the call. You will hear your OGM
followed by the caller's message through the handset receiver.
2.
If you decide to take the call, simply press the TALK button and begin speaking.
th
ring and announce "Memory full". You can erase
39606 rings, press the SCREEN
®
39606 will
(Figure 24)
(Figure 25)
(Figure 26)
(Figure 27)
Advertisement
Table of Contents
