Initial Setup - Bell Phones Excursion 39606 Manual

1. Plug the adapter into a standard AC outlet.
2. Insert the small plug into the adapter jack on the rear of the base as shown in Figure 9.
HANDSET BATTERY INSTALLATION
CAUTION:
Use only the Nickel Cadmium (Ni-Cd) battery type included with this unit. Use of other battery
types may cause injuries or damage.
Remove the battery compartment cover of the handset.
1.
2. Connect the rechargeable Ni-Cd battery as shown on Figure 10.

INITIAL SETUP

Before you can use your cordless telephone, the handset must be charged for at least 14
hours. See charging instruction on MAXIMIZING BATTERY LIFE section of this manual.
SETTING THE DAY AND TIME
1.
After 14 hours, lift the handset from the base unit.
2.
Press the REMOTE button on the handset. The
®
Excursion 39606 will prompt "You have no new
message. For help, press 9." followed by a long beep.
3.
Press 2. The unit will prompt "Time is off. Enter new day."
4.
After hearing a long beep, enter the new day (Sunday = 1, Monday = 2,
(Figure 9)
(Figure 10)
Insert the Ni-
3.
Cd battery into
the battery
compartment
of the handset.
Slide the
4.
battery
compartment
cover firmly in
its closed
position.
(Figure 11)