Table of Contents
Advertisement
MOUNTING POSITION
DESKTOP USE:
1.
Install and attach the wall mount bracket onto the
bottom of the base at the position as shown in Figure 4.
2.
Connect the telephone line cord to the TEL LINE jack
on the rear of the base unit and connect the opposite
end to the telephone modular jack.
WALL USE:
A. WITH A STANDARD AT&T OR GTE MODULAR WALL JACK
1.
Install the wall mount bracket at the position as shown in Figure 5.
2.
Connect the short telephone line cord to the TEL LINE jack on rear of the base unit.
3.
Connect the opposite end of the telephone line cord to the modular wall jack.
4.
Align the wall mounting slots with the studs located on the modular wall plate and slide
the base down to lock in place.
Base Unit
(Side View)
NOTE: If you do not have a standard modular wall jack, find a qualified technician to mount
one on the wall.
B. WALL MOUNTING (No Standard Wall Jack)
1.
Drill two holes with a vertical distance between the two marked positions of 3
(100 mm) as shown in Figure 6.
2.
Drive a screw into each of the holes. Tighten them to the end of the screw line, only
leaving the smooth part of the screw head outside the wall.
3.
Hang the unit onto the screws, then slide it down firmly to fasten the base securely.
Telephone Modular
Wall Jack
Wall Mount
Wall Mounting
Bracket
Slots
(Figure 5)
(Figure 6)
(Figure 4)
Stud
"
15/16
Advertisement
Table of Contents
