Turn Power Off/Remote Setup; Turning Off The Heater - OCI OCIE48EH Installation & Operation Manual

Turning heater off/Remote setup
Note:
During normal operation you can turn the heater to "HI" or "LOW" at
any time but once the heater is turned to "OFF" the heater will first light on
the "HI" setting for fifteen seconds and then default to the setting that was
used when the heater was last used. Either "HI" or "LO".

Turning off the heater:

1. To turn the heater "OFF" using the normal method you must simply press
the "OFF" button while the heater is turned on. The heater will simply go
through its cycle of turning the main burner off and then automatically turn
the heater pilot burner off. Once off the Heater defaults to the "HI" setting.
Programming the Remote Control:
The OCIE48EH must be programmed to the Remote control before it will
operate. It is possible to program up to three different remote controls to
each heater as well as program infinitely many heaters to one remote control
for multiple operation at one time.
1. To program the Remote (make sure power is on) locate the learn button
through the hole near the louvre on the right end of the heater. Using a small
allen wrench or other thin object press and release the learn button. There
will be a beep sound from the control module inside the heater. Then press
any key on the remote control. Once the internal receiver accepts the trans-
mitter code there will be a series of confirming beeps. The remote system is
ready for use.
14