Table of Contents
Advertisement
Wall Mounting/Bracket Assembly
Step Two, Wall Mounting:
overhead fixture keeping in mind installation specifications and clearances. The hole to
hole dimensions from one bracket to the next should be exactly 48" on center. Mount
the brackets into a solid material such as wall studs, Eave Joists, concrete block or com-
parable. Ensure that your installation can hold at least 100 lbs and resist extra strain
from weather/wind which may act on your installation. We recommend at least 3/8" lag
bolts but more substantial fasteners may be warranted in other situations. Consult a
licensed contractor if needed to determine what is best for your installation.
Step Three:
heater on the already mounted mount arm brackets using the (4) 3/8-16 X 3/4" SS button
head bolts, (4) 3/8 SS lock washers and (4) 3/8-16 SS hex nuts provided as shown
below. Position the heater according to the installation clearance section in this manual.
Do not exceed 30º from a level straight down installation. Warning: Mounting this
heater at more than 30º from a level straght down installation will cause the flue
products to melt the front screen or control unit. This is not covered under war-
ranty and will void the warranty on the heater! Tighten all mounting fasteners with a
7/32" allen wrench and 9/16" open end wrench. See diagrams below for variations of
mounting on wall or ceiling at either 0 or 30 degrees off of the floor. Note: Failure to
mount according to these instructions will void your warranty.
Ceiling mount level with deck.
Two people on step ladders will be needed for this step. Mount the
Ceiling mount at 30
from level with deck.
Mount the assembled mount brackets on the wall or
Wall mounting at 0
º
Wall mounting at 30
8
º
from level with deck.
º
from level with deck.
Hide quick links:
Advertisement
Table of Contents
