Playback Of Tape - Kenwood HM-535 Instruction Manual

Playback of TAPE

If you load a tape in the cassette deck in advance while the power is off, pressing the TAPE 2 3 key will
turns the power on automatically and starts the tape playback.
Selection of TAPE equalizer (TAPE EQ.)
To stop playback
To wind tape
at high speed
18 EN
Start playback
1. Load a cassette tape.
1
Press the area marked ) push open to open the cassette holder.
2
Insert a tape.
3
Press the area marked ) push open to close the cassette holder.
Do not use a cassette with more than 90-minute recording time, for the
tape used with such a cassette is very thin and tends to cause troubles
such as entanglement around the pinch roller or cutting off tape.
÷ The tape deck of the unit can play Normal (Type ) tapes.
÷ When there is a tape slack, wind the tape before loading.
2. Start playback.
Press the TAPE 2 3 key.
Displayed when the deck is loaded with a tape.
Reverse mode
indication
Transport direction indicators:
Indicates the tape transport direction during playback or recording by lighting
of 2 or 3. This direction is the direction stored in memory when the tape was
last stopped.
To wind tape at high speed
Transport direction indicators
Playback of TAPE
Start playback
To stop playback
r
Tape
counter