Channel Box Test Commands - Panasonic GSM EB-GD95 Service Manual

TEST AND MEASUREMENT

6.5. Channel Box Test Commands

The following table outlines the commands available using the channel box software.
After the telephone unit has been switched on (Section 6.4), use the up / down cursor keys on the PC keyboard to select the
channel box command. Use the left / right cursor keys to display the required indication and then press the ENTER key to
select the displayed function.
CHANNEL BOX COMMAND
TEST MODE
INITIALIZE
CHANGE CH GSM
CHANGE CH DCS
POWER LEVEL
TX DATA
RSSI (DBM)
SET AGC 1
SET AGC 2
SET AGC 3
SP LOOP BACK
PATH CONT
VOL. BUZZ
VOL. SIDE
VOL. MIC
VOL. SP1
VOL. SP2
GET KEY CODE
CONTROL OUT
CHECK LCD1
SET ER.DISP
SOFT SIM
TEST MODE
SIM STATUS
CHECK SUM
Issue 1
Revision 0
INDICATION
<TERM>
<ReST>
<INIT>
<xxx>
<xxx>
<xxx>
<NRL 0>
<NRL 1>
<NRL R>
<ACC R>
<xxx>
<xxx>
<xxx>
<xxx>
<START>
<STOP>
<MOSO>
<MESI>
<MESE>
<MISI>
<MISE>
<xx>
<xx>
<xx>
<xx>
<xx>
<ENABLE> <DISABLE>
<LED R>
<LED B>
<CHARGE ON>
<LED C>
<HF ON>
<ALL OFF>
<ALL ON>
<P1>
<P2>
<ENABLE>
<DISABLE>
<ENABLE> <DISABLE>
<TERM>
<SHOW>
<SHOW>
Terminates test mode.
Restarts test mode
When RETURN is pressed this will reset the default channel settings.
Sets up predefined channel settings for GSM frequencies.
Sets up predefined channel settings for DCS frequencies.
Allows a specified power level to be set at the UUT.
Sets TX Modulation to
Normal burst DATA all 0s
Normal burst DATA all 1s
Normal burst DATA all random
Access burst DATA random
Provides an RSSI reading on the User specified channel.
Allows changes to AGC levels on LOW, MIDDLE, HIGH channels.
Provides an audio path for use with the GSM test station
Sets audio loop-back from TX audio to RX audio without processing
by the CODEC
Sets audio paths:
MIC off speaker off
MIC external speaker internal
MIC external speaker external
MIC internal speaker internal
MIC internal speaker external
Sets buzzer volume between values 0 to 3 (Min to Max)
Sets 4 side tone volume levels between 0 dB and -18 dB
Sets 8 MIC volume levels between 26 dB and 40 dB
Sets speaker pre-amp volume levels
Sets speaker volume levels
Displays the value of a key pressed on the keypad
Switches on Incoming LED
Switches on Backlight LEDs
Switches charge sequence on LCD
Switches on Charging LED
Switches on handsfree mode
Switches off all above
Switches on all above
Provides 50% visual display of check pattern on the UUT LCD
Provides 100% visual display of check pattern on the UUT LCD
Unit error codes will be displayed on the UUT display
Unit error codes will not be displayed on the UUT display
With ENABLE set and TEST MODE <TERM> the UUT is removed
from test mode and can be placed into call mode
With SOFT SIM <ENABLED> the UUT will be removed from test
mode and can be placed into a call
Checks and displays the SIM status
Displays the software checksum
Section 6
– 36 –
FUNCTION
MCUK010801C8
Service Manual