Table of Contents
Advertisement
DISASSEMBLY / REASSEMBLY INSTRUCTIONS
2.
Carefully prise apart the case and cover, creating a gap at the base I/O connector. Insert the Case Separation Tool (see
Section 6) into the gap created, and gently slide the tool in the direction shown, ensuring that the moulded hooks separate
all the way up to point 'A'.
3.
Repeat step 2 for the opposite side of the telephone. Carefully twist the cover so that the hooks at position 'B' and those
at the corresponding position on the opposite side of the phone separate.
4.
Using a small screwdriver blade or similar blunt object, depress one of the RF Shield lugs (marked 'A' and 'B' in the diagram
below) to release the PCB from the case.
Issue 1
Revision 0
Figure 4.2: Case-Cover Separation
A
Figure 4.3: PCB Assembly Removal
Section 4
– 20 –
B
A
10467-1
B
10464-1
MCUK010801C8
Service Manual
Advertisement
Table of Contents
