Advertisement
The spread spectrum operation with automatic addressing insures immunity to interference.
The receiver is already matched to the transmitter. To change this:
Insert the BIND plug in the ch 6 position on the receiver.
Flashing LED on the receiver means that it is in matching mode.
When the receiver LED stops flashing (about 10 seconds) matching is done.
succeed
Turn off the receiver and install servo for ch 6, if used.
Bind button
start up
1. Turn on transmitter
2. Turn on receiver
3. LED comes on steady
bind)
s
turn it off.
port, and turn on the receiver.
connector
Bind plug
(Goes in Ch 6)
Second receiver is only on
some models, not HK-TR6A V2
transmitter.
Advertisement
