barigo PENTA Operating Instructions Manual page 28

PENTA
Setting mode for the alarm
The following steps are required for this in the alarm mode:
1. Press the S4 button for two seconds until you hear a double
signal tone. The indicator from the scale A3 will move towards
AM or PM.
(AM = ante meridiem "morning" 0:00 - 12:00,
PM = post meridiem "afternoon" 12:00-24:00)
2. In order to select AM or PM, press the S2 button.
3. Press the S4 button (single signal tone). The indicator of the
scale A1 will move to the currently set alarm time.
4. Press the S2 button to set the desired alarm time. To move
quicker, hold S2.
5. Press the S4 button (double signal tone) to exit the setting mode
for the alarm time.
The BARIGO PENTA automatically leaves the alarm setting mode and
changes to the alarm mode if no button is pressed for 2 to 3 minutes. After
leaving the alarm setting mode, the alarm function is turned ON.
28
Alarm