Appliance door, side panels
Remove any soiling from the
appliance door and side panels im-
If this is not done, it might become
impossible to remove and could
cause the surface to alter or
All surfaces are susceptible to
Contact with unsuitable cleaning
agents can alter or discolour the
^ The surfaces should be cleaned
using a solution of hot water and a
little washing-up liquid applied with a
soft sponge. They can also be
cleaned with a damp microfibre cloth
(without using any cleaning agent).
^ After cleaning, wipe with clean water
and dry with a soft cloth.
^ The ventilation gaps should be
cleaned regularly with a brush or
vacuum cleaner. A build-up of dust
will increase the energy consumption
of the appliance.
Do not use any oils or grease on the
door seal as these will cause the
seal to deteriorate and become
porous over time.
Cleaning and care
The door seal should be cleaned
regularly with clean water and then
wiped dry with a soft cloth.
Back of appliance -
compressor and metal grille
The compressor and the metal grille at
the back of the appliance (heat
exchanger) must be dusted at least
once a year. A build-up of dust will
increase the energy consumption of the
Make sure that the cable and other
components do not get broken off,
bent or damaged in any way during
^ Close the appliance door.
^ Reconnect to the mains and switch
the appliance back on.
^ Switch on the Super freeze function
so that the appliance can cool down
^ Once the temperature in the freezer
is sufficiently low, replace the glass
cold plates and drawers in the
freezer. Store the food in the drawers.
^ When the temperature in the freezer
is a constant -18 °C or colder press
the Super freeze button to switch the
Super freeze function off.