Changing the door hinging
The appliance is supplied right hand
hinged. If left hand door hinging is
required, follow the instructions below.
^ Close the door.
^ Unscrew lower hinge bracket a, and
^ Then lift the door down and off.
^ Take hinge pin b out of hinge
bracket a, then refit in the other hole
of the hinge bracket.
^ Remove cover c and use it to cover
the now empty holes on the opposite
^ Unscrew upper hinge pin d and refit
it on the other side.
^ Take care not to lose the washer.
^ Remove the cover at the top left of
the door and refit it on the opposite
^ Fit the appliance door from below
onto upper hinge pin d and then
close the appliance door.
^ Screw hinge bracket a into the lower
^ Use the long slots in the hinge
bracket to align the door. Make sure
you have tightened all screws