Table of Contents
Advertisement
Normal playback
Preparing for playback
Some preparatory steps are needed before starting playback.
SPEAKER
ON/STANDBY
ON/OFF
POWER
AUTO
ON/OFF
INPUT MODE
(KRF-V5060D/
V4060D/
V5560D)
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing POWER ON/
STANDBY
(for VR-605/615) or POWER ON/OFF and ON/
STANDBY
(for KRF-V5060D/V4060D/V5560D) key.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO2,
DVD or DVD/6CH (VR-615/KRF-V5060D only) jacks, make sure that
the input mode setting is correct for the type of audio signal to be used.
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is "TAPE". To change the
source to "MD", follow the steps below:
1 Use the INPUT SELECTOR knob to select "TAPE".
2 Hold down the AUTO key for more than 2 seconds.
• The source indication changes to "MD".
• To return to the original indication, repeat procedure 2.
Setting the speaker status
The speaker indicator lights up.
Press the SPEAKER key to switch the speaker ON or OFF.
POWER
ON/STANDBY
(KRF-V5060D/ V4060D/
V5560D)
(VR-605/615)
INPUT SELECTOR
Listening to a source component
SELECTOR
1
Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob.
VR-605/615/KRF-V5060D/V4060D/V5560D
1 "AUX"
8
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
6 "VIDEO2"
7 "DVD" or "DVD/6CH" (for VR-615/KRF-V5060D only)
KRF-V5060D (for the U.K. and Europe only)
1 "PHONO"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
6 "VIDEO2"
7 "DVD/6CH"
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOLUME keys to adjust
the volume.
VOLUME CONTROL
INPUT SELECTOR
INPUT
VOLUME
19
EN
Hide quick links:
Advertisement
Table of Contents
