Table of Contents
Advertisement
VORTEX FACTORY: Via E. Fermi, 5 – 27040 Campospinoso (PV)– ITALY – Tel. +39 0385 765200
3. ENGINE/CHASSIS ASSEMBLY
1
5 mm Allen Wrench + 10 mm Fixed
Wrench
Place the sprocket in the sprocket carrier and
tighten with washer and nut.
2
8mm Allen Wrench
Now place the engine on the chassis. Tighten
the engine mount clamps to the engine mount
lightly enough to hold the engine in position.
Do not tighten completely
3
Straight Ruler
Align the rear sprocket (in the axle) with the
front sprocket (in the clutch bell). Then install
the chain of proper length. Chain length varies
with gear sizes.
4
To adjust chain tension, move the engine ahead
until the proper tension is reached. Proper
tension is around 1 cm. of free up and down
movements.
Via dei Soprini, 16 – 25080 PREVALLE (Brescia) ITALY-Tel. +39 030 6804601 – Fax +39 030 6804698
OTK KART GROUP srl
Hide quick links:
Advertisement
Table of Contents
