Installation - Viessmann VITOSOL 200-F Installation Instructions Manual

Installing the connection set and collector . . .
1. Insert the plug as far as possible,
then secure it with hose clips.
2. Insert the connecting pipes as far
as possible, then secure them with
profile clips.
3. Fit the elbow to the return connec-
tor.
4. Fit the tee onto the flow connector.
5. Insert the sensor well into the tee,
counterholding the tee.
6. Insert the strain relief fitting into the
sensor well.
7. Insert the collector temperature
sensor as far as possible into the
sensor well and secure with strain
relief fitting.

Installation

!
Please note
Incorrect installation can lead to collector damage.
Use only gunmetal or brass fittings and copper pipes for the installation.
Use hemp only in conjunction with pressure and temperature-resistant
sealants (e.g. Viscotex Solarpaste from Locher, CH-9450 Altstätten,
Switzerland).
Never step onto solar panels.
Never solder near or on the collector.
50
(cont.)
8. Insert the support sleeves into the
connecting pipes of the solar cir-
cuit.
Make the connection between the
collector array and pipework of the
solar heating circuit.
9. Fit the thermal insulation and join
its cut faces with adhesive.
!
Please note
The collectors may be
damaged if the solar heating
system is not filled with heat
transfer medium immedi-
ately after installation.
Therefore, protect the col-
lectors against solar irradia-
tion by covering them up.