How To Use The Temperature Controller - Rinnai V75i series Installation And Operation Manual

How to use the Temperature Controller

Dimensions (inches): 3.5 W x 4.75 H x 0.75 D
The MC-91-2 controller is the standard temperature
controller that is supplied with the water heater. On
indoor models it is integrated into the front panel.
The MCC-91-2 controller is for hydronic applications
requiring higher temperatures. When the MCC-91-2
controller is connected, these higher temperatures
are available on all controller models in the system.
Refer to the section on temperature ranges.
DO NOT repeatedly operate the water heater and
then use a hot water tap while the controller is
turned off. Operating the water heater in this way to
alternately produce hot water may cause water to
condense on the outside of internal parts and
accumulate in the water heater cabinet.
WARNING

Before operating, smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.

Keep the area around the appliance clear and free
from combustible materials, gasoline, and other
flammable vapors and liquids.

Always check the water temperature before
entering a shower or bath.

Do not use this appliance if any part has been under
water. Immediately call a licensed professional to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.

Should overheating occur or the gas supply fail to
shut off, turn off the manual gas control valve to
the appliance.

Do not adjust the DIP switch unless specifically
instructed to do so.

Do not use an extension cord or an adapter plug
with this appliance.

Any alteration to the appliance or its controls can
be dangerous and will void the warranty.
30
In Use
Indicator
Temperature
Display
Temperature
Selection

If you install this water heater in an area that is
known to have hard water or that causes scale build
-up the water must be treated and/or the heat
exchanger flushed regularly. Rinnai provides a
"Scale Control System" that offers superior lime
scale prevention and corrosion control by feeding a
blend of control compounds into the water supply.
Damage and repair due to corrosive compounds in
the air is not covered by warranty.

Keep the air intake location free of chemicals such
as chlorine or bleach that produce fumes. These
fumes can damage components and reduce the life
of your appliance. Damage and repair due to scale
in the heat exchanger is not covered by warranty.
Value Series Manual
MC-91-2US
Priority
Indicator
Priority
Button
ON/OFF
Button