Alto IMAGE 26B Operator's Manual page 9

THE CONTROLS
The Traverse Switch (See figure 7, A)
The traverse switch is located on the control handle.
Light pressure with the thumb or hand activates the
traverse for forward movement.
The Reverse Switch (See figure 7, B)
The reverse switch is the white button located on top
of the handle. Reverse traverse is achieved by
simultaneously pressing the traverse and reverse
buttons.
Solution Tank (See figure 8, A)
The solution tank is top center of the machine. The
solution tank fill opening is located in the center of
the tank at the front of the machine.
Solution Tank Drain Hose and Solution Level
Indicator (See figure 8,B)
The solution drain hose is on the lower left at the
back of the machine. To drain, pull the clear hose
free of the top hosebarb and lay the hose into drain.
Reconnect when finished.
.Recovery Tank (See figure 8, C)
The recovery tank is mounted in the rear center
position on the machine.
Recovery Tank Drain Hose (See figure 8, D)
The recovery drain hose is located at the center
right at the back of the machine.
Battery Tray (See figure 9, A-C))
The battery tray must be pulled out of the machine on
the front bridge in order to change batteries or check
electrolyte. To lower bridge, grasp handle and pull up
firmly to insure handle is extended fully (A). Lower
bridge (B). Release lever on left side of battery tray
(C) and pull tray out slowly until latch arm engages in
slot on bridge (D) . To return battery tray to operating
position, release lever and slide tray back into
machine until lever engages in frame. Raise and
latch bridge. Close front.
Clarke Technology Operator's Manual IMAGE 26B
B
A
Figure 7
A
B
Figure 8
C
D
Figure 8
A
C
D
A
B
Page -9-