Attach Upper Handle - Hoover Vacuum Cleaner Owner's Manual

Attach Upper Handle

Remove clean solution
1.2
tank (upper tank).
1.4 1.5
Push bolts into holes Place nuts in recessed areas on back of handle.
on front of handle.
Hold each nut in place while tightening each
bolt securely with a Phillips screw driver.
If bolts will not go
through hole easily
Only two nuts are needed on this model.
handle is not pushed
The extra nut is not required but has been
completely down.
provided for your convenience.
Replace clean solution
1.7
tank (upper tank) by
positioning bottom first.
Press on tank handle
to snap top of tank
into place.
With cord hook to back
1.3
of cleaner, push upper
handle down onto
lower handle.
1.6
When handle
sections are
completely together,
squeeze trigger (A)
on upper handle to
snap trigger rod in
place.
Press cord into cord
1.8
clip on back of handle.
Pull cord tight.
5
A