Table of Contents
Advertisement
BACKGUARD
All charbroilers require a backguard. The
IDCB30 gives you the option of using an is-
land trim; 7 inch standard; 17 inch hi-back; 24
inch high shelf. IDCB15 comes with the op-
tion of an island trim or 7 inch backguard.
If you are using an island trim, a six inch
clearance between the back of the range and a
combustible surface is required. If an island
trim is to be used without this six inch clear-
ance, the back wall must be non-combustible
and heat resistant material that extends below
the top surface of the range a minimum of six
inches.
All backguards follow the same basic installa-
tion. Using hardware supplied, align the
backguard with the wrap around on each side
All specifications are subject to change without prior notification
INSTALLATION
and slip the tongue into place. A minimum of
six sheet metal screws (more depending on
width) are to be installed, three on each end
and more along the bottom edge.
Remove the charbroiler grates from the cook-
top surface. Four sheet metal screws to be
installed - down - into the cooktop support.
Two screws are installed on each end ring
grate/top grate position. Replace the removed
grates.
If you are installing a high shelf, there is an
additional channel to be installed on each side
first. The back guard then slips over this
channel as you put it into position. This chan-
nel provides extra support for the higher rise
of the 24 inch back.
P/N 750301 Page 14
Advertisement
Table of Contents
