Software / Firmware Upgrade Process; Alignment Procedure (For Function Adjustment) - BenQ M2700HD Service Manual

BenQ M2700HD
Net Weight (Kg)
4.9±0.3 Kg ( Net)
Package:
Carton Interior Dimension (mm)
LxWxH
4 .Cosmetic / Appearance / Alignment Service

4.1 Software / Firmware Upgrade Process

Upload firmware to MCU via VGA Cable
1. Connect ISP board between monitor and PC as below configuration.
Insert to
Parallel Port on
PC
2. Press the "connect" button in ISP.exe, and press "Read" button to load BIN file, then press "Auto"
button to enter ISP page, finally, press "Run" Icon to start ISP.
3. Waiting for "PASS", then please plug out power cable and re-start monitor again.

4.2 Alignment procedure (for function adjustment)

4.2.1 Preparation:
1. Setup input timing VESA to 1920*1080@60Hz,32-Grays pattern.
2. Setup units and keep it warm up for at least 30 minutes.
4.2.2 Timing adjustment
1. Enter to factory mode setting area (by pressing "ENTER"+ "MENU" + "POWER" at the same time during
power off).
2. Check the settings to following values:
Contrast =50;
Brightness=100;
Color enhancement=general;
3. Then turn off the monitor power.
4.2.3 Function key Definitions
4.2.3.1 Control buttons on the rear side of monitor
CONTROL KEY
Gross
Weight(Kg)
6.1±0.3Kg
760X578X280mm
ISP Board
Service Manual
Dimension w/o Base
LxWxH (mm)
512.39x348.35x99.63mm
Carton External Dimension (mm)
LxWxH
774X592X310mm
KEYS FUNCTION
11
Dimension w/ Base
LxWxH (mm)
512.39x348.35x163.35
mm
LCD
Monitor
D-Sub