Pride Mobility Jazzy Owner's Manual page 28

V I I . C A R E A N D M A I N T E N A N C E
To replace the batteries:
1. Turn off the power to the controller.
2. Make sure that the power chair is in drive mode. See III. "Your Power Chair."
3. Loosen the yellow thumbscrews (see figure 20) and remove the rear cover.
4. Disconnect the quick release battery connectors. See figure 3.
5. Remove the batteries.
6. Disconnect the battery harness from each battery.
7. Connect the battery harness to the new front battery according to the battery wiring diagram. See figure 20.
WARNING! Make sure you tighten the fasteners so that the connections are secure.
8. Connect the battery harness to the new rear battery according to the battery wiring diagram. See figure 20.
9. Install the new batteries and connect the quick release battery connectors.
10. Reinstall the rear cover.
11. Charge the batteries. See VI. "Batteries and Charging."
Figure 20. Battery Installation
28
BATTERY SET CONFIGURATION:
+ = POSITIVE (RED) TERMINAL POST
- = NEGATIVE (BLACK) TERMINAL POST
CONNECT RED WIRES TO RED POSITIVE (+) TERMINAL POSTS.
CONNECT BLACK WIRES TO BLACK NEGATIVE (-) TERMINAL POSTS.
QUICK RELEASE
BATTERY CONNECTORS
www.pridemobility.com
REAR COVER
FRONT BATTERY
BATTERY WIRING
DIAGRAM LABEL
YELLOW THUMBSCREWS
REAR BATTERY
Quantum/Jazzy 1450 Series