Sony Cyber-Shot DSC-P9 Operating Instructions Manual page 91

filename[D:\Documents and Settings\YAMANE\My Documents\WORKS\DSCP92\3082719111\3082719111DSCP92UC\02GB-
DSCP92UC\14trb.fm]
01cov.book Page 91 Tuesday, February 18, 2003 3:07 PM
Symptom Cause
The resizing function • Movie (MPEG movie)/Clip Motion/Multi Burst
does not work. files cannot be resized.
You cannot attach a print
• Print (DPOF) marks cannot be attached to movie
(DPOF) mark. (MPEG movie)/Clip Motion files.
You cannot cut a movie. • The movie is not long enough to cut.
• Protected movie (MPEG movie), Clip Motion,
Multi Burst files and still images cannot be cut.
Computers
Symptom Cause
You do not know whether
—
or not your OS can be
used with the camera.
You cannot install the —
USB driver.
Your computer does not • The camera is turned off.
recognize your camera. • The battery level is too low.
• You are not using the supplied USB cable.
• The USB cable is not connected securely.
• [USB Connect] is set to [PTP] in the SET UP
settings.
• The USB connectors on your computer are
connected to other equipment besides the
keyboard, the mouse.
• The camera is not directly connected to your
computer.
• The USB driver is not installed.
• Your computer does not properly recognize the
device because you connected the camera and
your computer with the USB cable before you
installed the "USB Driver" from the supplied
CD-ROM.
masterpage:L1adv-Right-04
Solution
—
—
—
—
Solution
p Check "Recommended computer environment" (pages 74, 84).
p In Windows 2000, log on as Administrator (authorized
Administrators).
p Turn on the camera (page 16).
p Use the AC Adaptor (not supplied) (page 15).
p Use the supplied USB cable (page 78).
p Disconnect the USB cable, and securely connect it again. Make
sure that "USB MODE" is displayed on the LCD screen
(page 78).
p Set it to [Normal] (page 103).
p Disconnect the USB cables except for those connected to the
keyboard and the mouse.
p Directly connect the camera and your computer without using a
USB hub.
p Install the USB driver (page 75).
p Delete the erroneously recognized device from your computer,
then install the USB driver (pages 75, 80).
91
model name1[DSC-P92]
[3-082-719-11(1)]