Table of Contents
Advertisement
4. If a mic is used, please select the corresponding front or rear mode
and set the device as default. In the above interface, you can adjust
the volume for recording and the playing volume for the mic.
5. If you need to set the output of multi-channel, you should right
click the mouse at the corresponding output interface. A dialog box
will be popped up, as shown in Figure 4.13.
6. Select Redistribution of Connectors. Then an interface will be popped
up, as shown in Figure 4.14. After that, set the corresponding output.
Figure 4.13
Figure 4.14
37
Advertisement
Table of Contents
